makett adatbázis | polc kezelés
GutterPunk
Tony G (GutterPunk)
GB

Meng King Tiger (Henschel Turret)

Hozzászólások

25 22 April 2021, 08:53
Treehugger
Looks really nice, especially if you created the zimmerit pattern by hand. 🙂
24 April 2021, 15:47
Tony G
No not by hand ... its the Meng Zimmerit .. a real swine to apply, breaks all over the place and will not bend!
24 April 2021, 16:36
Spanjaard
results seem to be good, but i am sure you work hard to get it there.
4 May 2021, 11:40
Sarunas D
Looks good to me. How was the track assembly? In this kit it is link-and-link type?
4 May 2021, 11:45
Tony G
Its a great kit, track assembly was ok (yes it was link and link) they provide you with a jig to setup the upper part of each track.
4 May 2021, 16:53
Neuling
Very good result!
17 May 2021, 09:12
Tony G
Thanks, nightmare with the Meng Zimmerit. Broke all over the pace and refused to bend into place ...
17 May 2021, 09:22
Mark Rogers
Hi Tony, I am just about to start this and like you have got hold of the meng zimmerit, any recommendation with installing it as i noted you said it would not bend?
28 May 2021, 14:27
David Taylor
Nice one.
28 May 2021, 15:50
Tony G
Hi Mark, im not sure how old the zimmerit was on the one i got. I bought it off a mate. The zimmerit was extremely brittle, on flat surfaces, as long as you are careful it should be ok, but around anywhere it should bend, it didn't and just fell apart (like around the front machine gun and the back of the turret). I did soak some bits longer and it seemed to help slightly. All i can say is go carefully and slowly, it will work in the end but be prepared for bits to fall off or break.
28 May 2021, 20:36
Mark Rogers
Thanks Tony
1 June 2021, 07:19

Project info

28 képek
1:35
Befejezve
1:35 King Tiger (Meng Model TS-031)1:35 Sd.Kfz.182 King Tiger Zimmerit Decal (Meng Model SPS-039)

Összes album

Összes album megtekintése »