WIP - Tornado GR.4
Kommentare
34 4 December 2020, 20:59
Przemek PrzybulewskiGlued main wheel wells.
Then air intakes and some engine compartment walls.
Working on engines and thrust reverser parts as those are installed as whole set
7 December 2020, 16:36
Przemek PrzybulewskiCockpit was glued in place - not without problems - rear wall had wrong angle.
Engines painted and positioned in rear fuselage.
Wings can have multiple option like open slots, flaps etc. And a very nice feature is rotating pylon mount points.
8 December 2020, 16:34
Stephen GLooking good! Are the issues with the kit mostly about the fit? How is the detail in general?
10 December 2020, 20:54
Przemek PrzybulewskiAdded top fuselage part in the rear section, this goes with wings. They are movable from straight to folded but not maximum folded.
Stephen G - fuselage is being build from many parts, they fit quite well, but small misaligment with one will cost you a lot of fitting and putty later.
Thanks Spanjaard
10 December 2020, 22:53
Przemek PrzybulewskiThank you Daniel
I finally managed to close cockpit and attach front part, so now plane looks like should be.
Also finished armament and started preshading on plane
29 December 2020, 08:59
DanielThe hanging stuff is looking just epic, masterclass in paint application 👍 what did you use on the canopy in 33?
29 December 2020, 22:50
Przemek PrzybulewskiDaniel, it was masking fluid but for artists not modelers. It is milky white wet but very transparent once dry.
I finished painting. It took couple of hours for preshading and s lot of time and paint layers to get to current stage
5 January 2021, 22:44
Przemek PrzybulewskiThank you - I have to think about some base for it. Usually at this stage base was already finished or almost finished. Now I do not even have a clue what to do 🙁
12 January 2021, 17:59
Przemek PrzybulewskiFinished - I did a base (if you want some detailed info - let me know).
Plane get some smoke and dirt and that's it.
15 January 2021, 12:27
Przemek PrzybulewskiThanks Konrad - yes, I highly recommend this kit. I's one of the best I've been working on.
It's quite expensive - I got mine with a discount but still it was 105-110$ but man, it's totally worth it.
15 January 2021, 14:18
