Still warming-up...
Kommentare
21 19 March 2022, 16:37
James C
Nicely done mate 👍
I like the 2 tone grey camouflage and have the same kit (a later boxing) in the stash as well.
Nicely done mate 👍
I like the 2 tone grey camouflage and have the same kit (a later boxing) in the stash as well.
22 March 2022, 04:13
Murad ÖZER
Guillaume and Simon thanks a lot guys.
James, just watch out for the radiator/wing to fuselage joint because unless it's very tight you'll have alignment issue with the nose section/engine covers later on. you'll see what i mean when you get there. problem is most likely flash but they are very fine and could go unnoticed easily coupled with the very tight tolerances of the parts. overall the fit is very nice, close to tamiya level.
this is if you opt to do a closed engine of course - if you decide to display it open then you'd be fine i guess.
also be careful with the main canopy as well, it's tight. hairdryer helps on a low setting to stretch it just a wee little bit before placing it immediately. there also is a single piece glazing if you chose a closed canopy but i didn't try it's fit.
cheers.
Guillaume and Simon thanks a lot guys.
James, just watch out for the radiator/wing to fuselage joint because unless it's very tight you'll have alignment issue with the nose section/engine covers later on. you'll see what i mean when you get there. problem is most likely flash but they are very fine and could go unnoticed easily coupled with the very tight tolerances of the parts. overall the fit is very nice, close to tamiya level.
this is if you opt to do a closed engine of course - if you decide to display it open then you'd be fine i guess.
also be careful with the main canopy as well, it's tight. hairdryer helps on a low setting to stretch it just a wee little bit before placing it immediately. there also is a single piece glazing if you chose a closed canopy but i didn't try it's fit.
cheers.
22 March 2022, 07:30