Lockheed P38J Lightning

The Version I will build

Upper side wings, original

Upper side wings with rivets engraved

…..without rivets

Here it‘s better visible, with rivets….

Official start !

Ready to set primer

The fit is really good, not much putty, not much sandin needed.

Weight in the Nose, in total 25 Gramm. I‘ve a lot of this nuts.

The clear parts are not extraordinary. The upper part on the Cockpit has a little turbidity. I think I can adjust this with klear. They are not really bad, but I saw better ones.

First Mr. Finishing Surfacer 1500, black, mixed mit Mr. Leveling thinner 110. Makes a very good Impression.

Two layers AK interactive Aluminum. Let’s see, what happens when I polish it.

After a few layers AK extreme Metal Aluminum, gloss coat, polishing it, now the panels with darker aluminum. It‘s a mix between dark aluminum and normal aluminum

Eduard decals are awesome! Wait 24 Hours after mounting the decals. Then you can, very, very carefuly, the covering film take away. First with a small piece of masking tape loose it a little bit, with a tweezer you can take it away. It‘s a fumbling job, but you‘ll love it. But be careful, the decals may not be older than from June 2021.

What stays on the plane is only the color of the decal. No carrier foil, just a perfect fit. Awesome!

Invasion stripes now on upper side of the wings. Next step is to put them on the lower side.

Now the invasion stripes are complete plus the decals. It was a fiddle work. The compressors are quite looking good, despite I wanted something different…