Yoshi 3D print

Finished. On a very simple display base.

Komentáře

8 16 December 2021, 20:02

Robin (WhiteGlint)
3D printed Yoshi to gain some more experience with resin figures.
Especially with cleaning and (brush) painting.

Here my job cleaning was not the best one and I need to be more diligent in the future.
I had less problems with my Catapult.
As I don't want to work with lots of isopropyl alcohol I cleaned Yoshi in warm water with dish detergent.

Some varnish will hopefully solve my problems as this little guy still is a bit sticky, even after the paint has dried.

16 December 2021, 20:24

S M
Do you have a cure machine or uv-light for curing the resodue resin?

16 December 2021, 20:39

Robin (WhiteGlint)
Yes, I use the Anycubic wash and Cure Station 2.0.
But even these tools need to be used right. 🤔
I think maybe I didn't clean good enough and did not cure long enough. Though curing too long should make the parts very brittle, I believe.

16 December 2021, 20:49

S M
Ok that's strange. Although I'm not an expert and I don't own any 3D printer. I have been dreaming of resin printer but my apartment is too small and I'm afraid of fumes. Maybe Santa will give me a garage some day...

17 December 2021, 16:59

Robin (WhiteGlint)
As I use the printer inside my house as well and I am not a fan of toxic fumes either, I use only plant-based resins which are not toxic.
But it still smells bad, especially when removing the cover from the printer after the print has finished. 😄
Using some protection like gloves and a mask is still very much recommended.

Working with plant-based resin may be an option for you.
The printer I am using is quite small too, so the parts I can print are not that large either. If you want I can provide you some pictures and measurements.

17 December 2021, 18:16

S M
Thanks! You can PM them to me. btw what is the source of that Yoshi's 3D-model?

17 December 2021, 22:56

Robin (WhiteGlint)
Yoshi's from Thingiverse.
thingiverse.com/thing:4788638

I'll write you a PM regarding the printer and so on.

18 December 2021, 09:15

Robin (WhiteGlint)
Finished. Fun little project. 🙂

19 December 2021, 14:23

S M
Nice base👍

19 December 2021, 18:32

Robin (WhiteGlint)
Thank you. 🙂

20 December 2021, 10:09