1:144 Dragon A-6 Intruder

The painting of the cockpit and the primer are finished. Kit seats on the right, aftermarket on the left.

Environmental Control System ram air intake from sprue

GBU-10 from Revell F-15E kit

GBU-10 from Revell F-15E kit

First I glued the smaller bombs on the triple ejector racks. Then I put the central fuel tank in place, followed by the GBU-10s on the outer pilons. After that I glued the landing gear doors and finally the two complete racks with the 5-5 Mk 82s on the inner pilons.

Komentáře

43 3 March, 15:49

Spanjaard
i am in 🙂

4 March, 14:52

Freak
You do know how to create anticipation, putting a detailed cockpit into a 1:144 A-6.

4 March, 21:33

Nagy-Meszler Csaba
The cockpit is a product of RetroWings. 😊 The cut was a little bigger than it should have been. 😅 I use Tamiya Epoxy Putty, then when it has set, I paint it.

5 March, 08:16

Freak
Lovely progress pictures! I'm taking notes on how to layer a US Navy plane, this is a masterclass!

2 April, 06:38

Nagy-Meszler Csaba
Thank you Freak! I hope it is useful. 😊

2 April, 08:50