Hasegawa A-6E Intruder low viz
starboard wing assembled
fuselage closed up
port wing attached to the fuselage
starboard wing and horizontal stabilizer attached
radome, exhaust nozzles, and speed brakes assembled
intakes added
top fuselage seam filled and primed
bottom fuselage seam work
main areas painted
working on the canopy
glosscote applied
first decals
some left side decals
canopy finally fixed and refuelling probe on
more decals
Comments
25 July 2017, 02:39
Ed HubbartThanks all. The pictures don't show it, but I actually had to relocate the port wing slightly. When I went to install the exhaust Monday night, it wasn't sitting flush, so I had to remove the wing, put the exhaust piece in where it went, and then reglue the wing in the proper alignment.
13 September 2017, 13:49
Holger KranichWhat markings will you give her? Desert Storm?
I guess it was not easy to remove the wing, hu?
13 September 2017, 13:54
Kerry COXEd, are you guilty of Not following the instructions Eh.? Mmmmmmmmm
13 September 2017, 13:54
